Kunshan Bojin Trading Co., Ltd.

Fully Automatic Wire Winding and Cutting Machine

Laser cutting machine: During the cutting process, the beam is focused into a small focus by the lens of the cutting head, so that the focus reaches a high power density, in which the cutting head is fixed on the Z axis. At this point, the heat input from the beam far exceeds the amount of heat reflected, transmitted or diffused by the material, and the material is quickly heated to the temperature of melting and vaporization. At the same time, a jet of high-speed air blows molten and vaporized material out of the side of the coaxial or non-coaxial line, forming holes cut by the material. With the relative motion of the focus and the material, the hole forms a continuous narrow slit to complete the material cutting.

Safe operation procedures for rubber packing equipment: Correctly install the wire to each mechanical part to adjust the wiring arrangement and position of the wire collector and observe the melting state of the adhesive. If the glue melts well, proceed to the next step: Turn on the power switch of the tension controller of the tractor, start the tractor to start the pickup line, slowly speed up, observe the location of the pulley on the storage line, if the pulley leaves the roller, increase the pickup speed or reduce the traction speed. Adjust the traction and receiving line speed, so that the pulley does not break off the displacement roller and is in the minimum fluctuation state.

Maintenance of winding machine: Make good use of various adjustable parts: such as winding tension, screen voltage, starting position of wire rack, etc., which is a simple but effective method in maintenance. Some innocuous faults can be corrected by adjusting the adjustable parts. For example, if a winder has been maintained in an enterprise for many years, the display screen of the system is dark and normal after adjusting the screen power supply voltage. The company integrates R&D, production and sales of automatic winding machine, automatic production line, various non-standard automatic welding machine and non-standard automatic equipment.

The power system of fully automatic wire winding and cutting machine provides power for industrial control computer and motion control card. In order to protect the automatic winding machine, due to the impact of sudden power loss on the system and software, this part and the rest of the electrical parts of the equipment do not share a set of power supply lines, but independently distribute power supply, and equip the industrial computer with 500W stabilized power supply. Keep the industrial computer running for more than half an hour in case of sudden power failure. The servo driver and equipment heating system share a set of power supply system. The power supply of the system is 1.5 times of the designed power of the equipment.
  • TEL:+86-512-57169166
  • EMAIL:salome@bojin.hk
  • ADDRESS:11th Floor, Jingzuan Building, NO. 875 Xiaolin Road, Kunshan, Jiangsu, P.R.C.